MacAllister MSCD18-Li-2 - Product Functions: Torque Adjustment

27
MSCD18-Li-2
In more detail . . .
Product functions
WARNING! To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation or the two-speed gear
control. When overload occurs frequently on the high speed gear, switch to
the low speed gear to avoid the motor overheating.
Torque adjustment (Fig. 14)
The torque is adjusted by rotating the torque adjustment ring (3). The torque is greater
when the torque adjustment ring is set on a higher setting. The torque is lower when
the torque adjustment ring is set on a lower setting.
Torque Description
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 14 for driving screws into soft and hard material
15 - 17 for driving screws into hard wood
18+ for driving larger screws
for heavy drilling in wood,plastic and metal
for impact drilling in masonry and concrete
Fig. 14
3