23
CPE can’t connect with AP
(the status display unconnected)
Try to scan the avaliable wireless networking again;
Make sure the CPE’s wireless standard (11b/g/n, 5.8G)is correct;
The Security and passwords are matched between CPE and AP;
The signal strength of AP is too weak to connect, should be more
than -75dBm;
Can’t scan the wireless AP Scan it several times more;
Make sure there are 5G signal existed.
Reset the CPE, scan it again after CPE restart;
The connection of CPE and AP is success, but the
computer can’t share internet
Pls Check the computer’s IP address and DNS setting. If it is dy-
namin, set the network card as automatically obtain. If it is static
IP, pls contact with ISP for correct IP address and DNS address.
How to Reset CPE How to Reset CPE
Press the “Reset” button more than 15 seconds after power on.
The CPE will restore factory default after the CPE restart.
To Next Page
Loading...