Macintosh Classic - Unable to Insert Disk All the Way; Does Not Eject Disk; Internal Floppy Drive Runs Continuously

Troubleshooting Symptom Charts/Floppy Drives (Continued) - 7
Floppy Drives (Continued)
Unable to insert disk
all the way
1 Insert opened paper clip into hole beside floppy drive.
2 Switch off system and hold mouse button down while
switching system on (to complete eject cycle).
3 Replace floppy drive.
Does not eject disk 1 Insert opened paper clip into hole beside floppy drive.
2 Switch off system and hold mouse button down while
switching system on (to complete eject cycle).
3 Replace floppy drive.
Internal floppy drive
runs continuously
1 Replace bad disk with known-good disk.
2 Replace floppy drive.
3 Replace logic board. Retain customer’s SIMMs.
4 Replace floppy drive cable.