Replacement
1. After determining which molded Nylon end needs to be replaced, cut the nylon tubing off just behind the barb.
Note: Make a nice clean, square cut.
W2006149
2. Clamp the tubing in the jaws, special tool number 85111500, and carefully insert the Nylon end in by using a soft
tipped hammer or a small arbor or drill press.
Note: To press in the new end, the Nylon tubing must be held in the special serrated jaws.
W2006150
3. The Nylon end can be pressed in with a small arbor press or a small hammer if used carefully. The Nylon tubing
should stick out of the pliers about 1/4 inch.
Note: For ease of assembly, small hand tools as shown are available.
W2006151
4. The Nylon should be pressed down into the Nylon tubing so that all barbs are fully inserted. Care should be taken to
keep all parts clean.
5.
The Nylon tube need not be heated for assembly.
Mack Body Builder Instructions CHU, CXU, GU, TD, MRU, LR
USA139046859 Date 5.2017 Body Builder; Engine, MP7, MP8, and MP10 Page 42 (43)
All Rights Reserved
To Next Page
Loading...
