Mackie CR-X Series - Page 5

5
快速指南
快速指南
1 7
8
2
3
6
6 4
3
5
1.ReadandunderstandtheImportantSafetyInstructionsonpage2.
2.MakeallinitialconnectionswiththepowerswitchesOFFonallequipment.Makesurethe
monitor’svolumecontrolisallthewaydown.
3.Connectan1/8"todualRCA(or1/4")cablefromtheoutputofacomputertotheinputs
ontherearpanelofthemonitor.
4.Connectblack(–)andred(+)speakerwiresfromthepoweredmonitor’s±springclips
tothepassivemonitor’s±springclips.
5.Plugthea󽗋xedlinecordintoanACoutlet.
Themonitormayaccepttheappropriate
voltageasindicatedonthebackpanel.
6.Turnthecomputeron.
7.TurntheCR-Xmonitoron.
[Rearpanelpowerswitch].
8.Playanaudio󽗉leandslowlyturnthefrontpanelvolumecontroltoacomfortablelistening
level.
Getting Started –