Quick Start Guide
Quick Start Guide
9
Mixer Hardware : Wireless Setup
Step 5: In the iPad’s Wi-Fi settings
page, select the name of the wireless
network you created. This might be
the default name of the router. You
might also have to enter the router’s
default password at this time. Make
sure the correct network is selected.
Step 6: Slide the iPad into the dock
of the mixer, if it isn’t already.
Step 7: Launch the Master Fader
app.
Step 8: Click the Gear icon to display
the Tools menu. From here, select
Devices.
Step 9: There will be three unique
sections listed: Work Offline/
Demo, Wired and Wireless. At this
point the Wired DL806 or DL1608
should be selected. Now leave the
Tools menu and reconfirm that the
DL806 or DL1608 may be controlled
from Master Fader over the wired
connection.
Step 10: Go back to the Tools >
Devices menu. Now undock the iPad
from the mixer and select the
Wireless DL806 or DL1608 from the
devices list.
At this point you should be able
to control the mixer wirelessly.
Also, “CONNECTED” should
now be displayed below the
Tools icon.
If “DISCONNECTED” is shown, or the
DL806 or DL1608 is not shown in the
wireless devices list, please follow
the directions again, step by step,
and also check out the Reference
Guide for more detailed instructions.
If all else fails, contact our splendid
technical support heroes.
See page 31 for contact information.
That wasn’t so bad now, was it?
Hardware complete, commence
with software. Turn the page to learn
more about the Master Fader app...
In most cases, the router will handle
this task. However, there are some
routers that can’t complete this
simple assignment and should not be
used. Routers with a single Ethernet
port often will not work well with the
DL806 and DL1608 for this reason.
(3) 802.11n. We prefer and strongly
suggest going with an 802.11n as
your Wi-Fi mode. However,
802.11g also works.
(4) Name. We are not in the business
of suggesting what Wi-Fi router
to go with, but choosing one with
an instantly recognizable, quality,
trustworthy brand name doesn’t hurt.
OK let’s go!
Step 1: Turn the mixer off.
Step 2: Plug in the Wi-Fi router. Most
of the default router settings will
work with your mixer, but you might
need to configure the wireless router
first. Please refer to the router’s
manual for detailed information.
Step 3: Connect an Ethernet cable
between the mixer and router. Make
sure you are using a LAN port on the
router, not a WAN port!
Step 4: Turn on the Wi-Fi router first
and wait for it to completely boot up.
Good? Now turn on the mixer.
To Next Page
Loading...
Need help?
General
