To Next PageTo Next Page
Need help?Do you have a question about the Mackie M-1400i and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Amplifier Class | AB |
| Number of Channels | 2 |
| Total Harmonic Distortion (THD) | <0.03% |
| Signal-to-Noise Ratio | > 100dB |
| Input Sensitivity | 1.4V |
| Input Impedance | 20 kOhms balanced, 10 kOhms unbalanced |
| Power Output (Bridge Mono, 8 Ohms) | 1200W |
| Frequency Response | 20Hz - 20kHz |
| Cooling | Fan cooled |
| Protection | Short circuit, thermal, DC |
| Connectors | XLR and 1/4" TRS |
| Dimensions (H x W x D) | 89mm x 483mm |
| Damping Factor | >500 |
Covers numbered safety instructions for reading, retaining, heeding warnings, and following operational guidelines.
Guide to initial installation, including mounting and ventilation requirements for the amplifier.
Details on making connections and setting initial controls like Gain, Low Cut Filter, and Limiter.
Detailed explanation of the GAIN knobs, input sensitivity, and constant gain vs. sensitivity philosophies.
Explanation of PROTECT, SHORT, and TEMP STATUS LEDs and their causes.
Guidance on setting CD frequency and selecting the AMP MODE (STEREO, MONO, BRIDGE).
Instructions for BRIDGE mode operation and using the OUTPUT APPLICATION switch.
Details on the active SUBWOOFER filter and its use as a crossover.
Explanation of the LIMITER's role in preventing speaker damage from clipping.
Steps for obtaining warranty service, including obtaining an RA number.
Guidance for diagnosing and resolving issues like no power or no sound.
Troubleshooting for other problems and instructions on how to send the unit for repair.
Information on warranty coverage, service procedures, and how to make a claim.
