Do you have a question about the Mackie ProFX22 and is the answer not in the manual?
Channels | 22 |
---|---|
USB Interface | Yes |
Phantom Power | Yes |
EQ Bands | 3-band |
Built-in Effects | Yes |
Type | Analog |
Outputs - Main | 2 |
Steps to reset all mixer controls to their default positions.
Guide for connecting audio sources and outputs to the mixer.
Procedure for adjusting input signal levels for optimal performance.
Basic steps to achieve sound output and start mixing.
Details the mixer's built-in processors, compressors, and overall design.
Explains the 2x2 USB interface for recording and playback.
Details the standard 3-prong IEC power connector.
Explains the operation of the mixer's power switch.
Describes the functionality of the 2x2 USB interface.
Female XLR connector for microphone and line level input.
Explains 48V phantom power for condenser microphones.
Details the 1/4" jacks for connecting line-level sources.
Explains the 1/4" TRS/TS inputs for stereo line-level signals.
Describes the 1/4" jacks for connecting serial effects processors.
Adjusts the input sensitivity for mic and line inputs.
High-pass filter to reduce bass frequencies below 100 Hz.
Describes the 3-band EQ with shelving and peaking controls.
Controls high-frequency adjustment up to 12 kHz.
Semi-parametric mid-sweep EQ for mono channels.
Peaking mid EQ control for stereo channels.
Controls low-frequency adjustment below 80 Hz.
Controls for setting up monitor mixes independently from the main mix.
Controls for sending signal to the internal FX processor.
Adjusts the channel signal's position between left and right outputs.
Indicator for signal overload before the channel fader.
Silences the channel's signal output.
Selects main mix or subgroup destinations for channel signals.
Pre-Fader Listen switch for monitoring individual channels.
Adjusts the final level of each channel to the main mix.
Routes stereo USB playback to the last stereo channel.
Output for stage monitor mixes.
Output for external effects processors.
Connects a footswitch to control internal effects mute.
Stereo inputs for processed signals from external effects.
Main stereo outputs for connecting to amplifiers or speakers.
Outputs for monitoring.
Outputs for multitrack recording or secondary amplification.
Headphone output for monitoring.
RCA connections for tape, CD, or iPod playback/recording.
Global switch to enable phantom power for all mic inputs.
Indicates when the mixer is powered on.
7-band graphic equalizer for main mix output adjustment.
Switches for EQ routing and bypass, and monitor mix selection.
LED meters for signal level and solo status indicator.
Controls for aux monitor/FX sends, returns, and internal effects.
Controls for USB output, 2-track return, and input muting.
Controls levels for control room and headphone outputs.
Assigns channels to subgroups and controls their levels.
Master stereo fader for main line-level outputs.
Tips for diagnosing and resolving common mixer problems.
Details on noise, power issues, and obtaining service.
Explains wiring and use of common audio connectors.
Lists technical details including noise, distortion, and impedance.
Visual layout of mono channel controls.
Visual layout of compressor and stereo channels.
Visual layout of master section controls.