Need help?Do you have a question about the Mackie SRM350v2 and is the answer not in the manual?
General| Woofer Size | 10" |
|---|---|
| Tweeter Size | 1.4" |
| Max SPL | 121 dB |
| Crossover Frequency | 2.5kHz |
| Outputs | XLR |
| Type | Active |
| Tweeter Material | Titanium |
| Frequency Response | 55Hz - 20kHz |
| Inputs | XLR |
| Input Impedance | 10k ohms |
Details on the high-power low-frequency woofer and titanium diaphragm compression driver.
Information on the Class-D and FR Series power amplifiers and their features.
Explanation of the built-in 24 dB/octave Linkwitz-Riley electronic crossover.
Description of the strong molded composite cabinet and its design features.
Step-by-step instructions for initial setup and operation.
Connection point for the AC power linecord.
Control for turning the unit on/off and standby mode.
LED status light indicating power availability.
Filter switch to adjust low and high frequencies for a punchy sound.
Adjusts the signal level going into the power amplifiers.
Selects input sensitivity for microphone or line-level signals.
LED showing when a signal is present at the input.
LED indicating when the limiter circuit is active.
Combo XLR/1/4" TRS jack for signal input.
Male XLR output for daisy-chaining signals.
How room acoustics affect sound and how the speaker minimizes issues.
Guidance on distributing AC power for audio and lighting systems.
Common problems and solutions for no power or no sound.
How to address situations where one speaker is louder than the other.
Identifying causes for diminished bass response.
Troubleshooting distorted or poor audio output.
To Next Page
