999051 – Revision B Page | 29 of 40
11.2 Inspection
Inspection is to be completed prior to each use by the user of the Mobile Hoist.
Should any of the components in the table below fail the inspection, DO NOT use the Mobile Hoist.
Contact your local authorised dealer for service – contact details are on the last page of this manual.
Ensure all component inspections in the Table below are completed prior to each use of the Hoist.
Check List before Use
Service/Inspection required
Visual inspection of the external of the Mobile Hoist. Significant damage that may
affect the function of the Mobile Hoist along with a clear safety hazard is
Check the Labelling on the Mobile Hoist to ensure they are all still legible, this
includes the Serial Number and other important markings. If labels are not legible,
then contact your local authorised dealer immediately.
Check all main nuts and bolts to see if they are loose, If they are not tight or you
have concerns, then contact your local authorised dealer immediately.
An authorised/competent service company or person will issue a test certificate
after satisfactory completion of the LOLER inspection. The certificate will be valid
The battery pack should not require maintenance other than the regular charging
as detailed in the charging instructions.
Check the emergency stop button functionality
Check the manual emergency lower functionality.
The actuator should not require maintenance other than checking for correct
operation, listening for unusual noise and checking for any damage.
The actuator should not require maintenance other than checking for correct
operation, listening for unusual noise and checking for any damage.
Check the brake functionality on each rear castor. Check all castor fixing points.
Check that each castor runs free and rotates easily. Remove any build-up of hair,
Check the smooth opening and closing of the legs.
Inspect all male plugs and female sockets for correct fitting. Inspect the hand
control functionality.
Ensure the mast fully engages into the base housing. Check the operation of the
mast locking hand wheel. Check the actuator mounting brackets for excessive
Check the attachment of the boom to the mast, ensure all fixing points are secure
and free from wear.
Check the carry bar rotates and swings freely. Check the central pivot bolt and
nylon lock nut for excessive wear. Check the fixing point for excessive wear and
inspect the sling hooks for any damage, sharp edges and excessive wear.
Inspect Carry Bar wear washer, ensure the washer has not fully warn, if so,
replacement in required.
To Next Page
Loading...