Need help?Do you have a question about the Macma MM2315 and is the answer not in the manual?
Essential safety guidelines for operating the belt sander safely and preventing accidents.
Specific grounding requirements for circuits rated less than 150 volts.
Specific grounding requirements for circuits rated 150-250 volts.
Setting the belt in vertical position and locking the plunging table at the lowest position.
Adjusting the sanding table angle from 90 to 180 degrees for horizontal belt position.
Adjusting the roller to track the belt while the sander is running.
Adjusting the miter gauge for sanding mitre angles between 45 and 90 degrees.
Techniques for performing contour sanding operations.
Mounting the locating plate for flat sanding and securing the job.
Detailed list of components and their quantities for the belt sander.
General| Sander type | Random orbital sander |
|---|---|
| Power | 300 W |
| No-load speed | 12000 rpm |
| Sanding plate size | 125 mm |
| Weight | 1.5 kg |
To Next Page