Macurco CM-E1 - Page 4

4
CM-E1 Carbon Monoxide Detector
 The CM-E1 is not intended for use in industrial
applications such as refineries, chemical plants and or
for use in parking garages as to control exhaust fans
 The small, low profile unit is in a white plastic case. It
surface mounts to a wall using the supplied rear housing
or flush mounts in a 2 x 4 x1-1/2 inch deep single gang
switch or handy electrical box
 Can be Field Tested with Carbon Monoxide Gas
 900 square feet coverage
The CM-E1 is a low voltage detector of Carbon Monoxide. The CM–E1
is designed for connection to UL Listed Fire Alarm/Burglary Control
Panels. The CM-E1 is intended for non-hazardous locations such as
residences, retail stores, office buildings, and institutional buildings