Macurco CM-E1 - Page 9

9
CM-E1 Carbon Monoxide Detector
 Quickly press the TEST/RESET button 5 times.
The buzzer will do a quick double beep and the
LED will flash Amber alternating with a pause
 Aim the nozzle of the aerosol can at the buzzer
grate area and press for 4 to 5 seconds
 Wait for a few seconds. The LED should blink
Green rapidly and the buzzer should double beep
every 15 seconds - Pass
 Press the button once to return to normal mode
The CME1-FTG is an 11L 500 ppm Aerosol Carbon Monoxide Field
Test Gas. This field test gas allows installers to do a Functional Test
of the CO sensor. The flow rate of the CME1-FTG is 10 LPM providing
enough gas to quick test 20-30 CM-E1 Carbon Monoxide sensors