Mad Catz 4704 User Manual

Wireless Gaming Adapter Manual
You must have at least the following equipment before you begin setup:
• A Wireless Access Point (AP) or wireless Router (with Broadband Internet
Connection)
• A Computer with an Ethernet Adapter
and CD-ROM drive
• An Ethernet Cable (included)
• A CD-ROM (with Manual and quick installation guide)
1. Hardware installation:
1-1 Connect one end of power adapter to power port on Wireless Gaming Adapter
and connect the other end into an available electrical outlet. Once connected,
push Adapter's power button to turn Adapter ON.
1-2 Connect Ethernet cable between computer and Gaming Adapter’s Ethernet port.
2. Software installation:
2-1 IP address setting
You must assign your computer a static IP address within the same range as the IP
address of the Gaming Adapter. The Gaming Adapter’s default IP address is 10.10.10.254
with a Subnet mask of 255.255.255.0. Please see the detailed information below:
2-1-1 Click the Start button (it should be located at the lower-left corner of your monitor), then
click
Control Panel. Double-click Network Connections, then double-click Local Area
Connection, Local Area Connection Status window will appear, and then click “Properties”
2-1-2 Set the IP address of your Ethernet adapter to a specific IP address.
In the
IP address field, enter the address 10.10.10.x(x should be replaced by a number
between 2 and 253,such as 101). In the
Subnet mask field, enter 255.255.255.0.

Mad Catz 4704 Specifications

General

Brand	Mad Catz
Model	4704
Category	Adapter
Language	English

Summary

Hardware Installation

Connect Power Adapter

Connect the power adapter to the adapter's port and an electrical outlet, then turn it on.

Connect Ethernet Cable

Connect the Ethernet cable between your computer and the adapter's Ethernet port.

Software and IP Configuration

Configure Static IP Address

Set your computer's static IP address and subnet mask via Network Connections properties.

Gaming Adapter Setup Wizard

Start Setup Wizard and Connect Hardware

Insert setup CD, launch wizard, and follow prompts for power and Ethernet connections.

Configure IP Address and Check LEDs

Assign static IP address, subnet mask, and verify adapter LED status.

Connecting to Wireless AP/Router

Choose Connection Method (WPS or Web Setup)

Select between WPS (Wi-Fi Protected Setup) or Web-based Utility for connection.

Configure WPS Connection (Push Button/PIN)

Use WPS Push Button or PIN Number methods to connect the adapter to your wireless AP/Router.

Configure Web-based Utility

Log in to the web-based utility to perform site survey, WEP configuration, and activate profile.

Activate Wireless Profile

Select and activate the desired wireless profile to complete the connection.