Connect and Activate the Power Meter
Connect the Power Meter Device
Note:
The box should contain:
The power meter is not activated and cannot be used normally; the
new product must be activated for the first time.
Android users to enter the google Store(iPhone users from the
Appstore) to search for the "Magene Utility" app and download it.
Follow the prompts to activate your power meter.
Note:
If the activation fails, please click back to enter the device
search list and reconnect to activate.
Magene Power Meter can be connected to power device after activation.
Typically, most bike computers can search for and add power meter equipment in the settings
through the settings>sensors>new>sensor>power meter.
Note:When searching for the Magene Power Meter, step on the pedal connected to the power
meter crank so that the power meter can detect the torque therefore waking up the power
meter from Sleep mode, start the Bluetooth or ANT + signal broadcast and wait for a device to
connect.
Note:If there are multiple power meters in the current environment, you need to identify
your power meter by ANT+ ID.
Magene Power Meter is a Bluetooth and ANT+ dual-protocol power meter that is compatible
with ANT+ and Bluetooth devices that support the standardized power meter protocol. Using this
protocol the power meter's measured data can be viewed and recorded.
Quick start Guide
Accessory Bag
Charging line
Right power crank
2
Left power crank
Scan to download
Magene Utility
To Next Page
Loading...
Need help?
General