Door Reversal Instruction
Your refrigerator is built with a reversible door. You have the choice of either opening it from the left
or the right side. In order to reserve the opening direction of your door, please follow these simple
instructions:
Remove all goods in your refrigerator. Tilt the refrigerator backwards. Secure the rear from sliding.
Tape the door to the cabinet to prevent from falling.
Note: If you have assembled legs on your refrigerator, you will have to remove the short leg
from base bracket before beginning. And reinstall it back to the base bracket after you
complete it.
1. Remove the 3 hexagonal screws from base bracket.
2. Remove the pivot holding the bottom of the door.
3. Separate the door from the cabinet and remove the pivot axle from the upper side of the door.
Remove and reinstall upper and lower axle door inserts to opposite side.
4. Install the pivot axle to opposite side.
5. Re-attach the door to the cabinet and secure with tape.
6. Attach the base bracket to the opposite side.
7. Install the bottom pivot aligning with the lower pivot insert on the door. Attach the 3 hexagonal
screws to base bracket.
8. Remove tape.
9. As the unit was tilted, wait 24 hours before plugging it in.
8
To Next Page
Loading...
Need help?
General
