8
The oven light is on when the microwave oven is
operating.
The oven door can be opened at any time during
operation by pushing the door release button on
the control panel. The oven will automatically shut
off.
Each time a pad is touched, a BEEP will sound to
acknowledge the touch.
The oven automatically cooks on full power unless
set to a lower power level.
The display will show “ : 0” when the oven is
plugged in.
Time clock returns to the present time when the
cooking time ends.
When the STOP/CLEAR pad is touched during the
oven operation, the oven stops cooking and all
information retained. To erase all information(except
the present time), touch the STOP/CLEAR pad once
more. If the oven door is opened during the oven
operation, all information is retained.
If the START pad is touched and the oven does not
operate, check the area between the door and door
seal for obstructions and make sure the door is closed
securely. The oven will not start cooking until the door
is completely closed or the program has been reset.
OPERATION PROCEDURE
This section includes useful information about oven operation.
1. Plug power supply cord into a standard 3-pronged 20 Amp, 120V AC 60Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
1
2
3
4
5
6
7
8
Make sure the oven is properly installed and
plugged into the electrical outlet.
WATTAGE OUTPUT CHART
•
The power-level is set by touching the POWER pad. The chart shows the display, the power level and the
percentage of power.
Touch POWER pad Power level (Display) Approximate Percentage of Power
once P-HI 100%
twice P-90 90%
3 times P-80 80%
4 times P-70 70%
5 times P-60 60%
6 times P-50 50%
7 times P-40 40%
8 times P-30 30%
9 times P-20 20%
10 times P-10 10%
11 times P-00 0%
To Next Page
Loading...
Need help?
General
Weight and Dimensions
