11
ENG - 11
Lock and Unlock
• The lock feature is designed to prevent the settings of your wine and beverage center
from being adjusted accidentally. In order to adjust any of the settings you must
unlock the control panel by pressing the lock pad for approximately 3 seconds.
Once the unit is unlocked, an audible beep will be heard and the lock indicator
light will turn off.
• If no selection is made to adjust the unit in approximately one minute, the control
panel will automatically return to the lock mode.
• To lock the unit manually, press the lock pad.
• Under locked mode, the control pad function is disabled, and the lock indicator
light will flash for 5 seconds to remind you that the control panel is locked.
Temperature Setting
• Unlock the control panel by pressing the lock pad for approximately 3 seconds.
Once the control panel is unlocked, an audible beep will be heard and the lock
indicator light will turn off.
• Under normal conditions, the temperature display indicates the current temperature
of the corresponding zone. When adjusting the temperature, the temperature display
will flash to indicate that the temperature is being adjusted.
• The temperature in the upper & lower zones can be set independently by pressing
the warmer or colder touch pads corresponding to the desired zone. The
temperature range of both zones can be set between 39
o
F to 61
o
F (4
o
C to 16
o
C).
• When the warmer or colder pad is pressed, the temperature displayed will
increase or decrease in increments of one degree. If the warmer or colder pad
is pressed and held for 2 seconds, the temperature displayed will increase or
decrease at a speed of one degree per half second.
• Once you have adjusted the upper and/or lower zone to the desired temperature,
release the temperature pad. At this time the temperature displayed will flash for
approximately 3 seconds to confirm the selected temperature. Once the display stops
flashing the temperature display will indicate the current temperature of that zone.
Note: The temperature display can be changed between Celsius and Fahrenheit by
simultaneously pressing and holding both warmer and colder pads for about 3
seconds. This unit cannot be in lock mode to perform this operation.
Interior Light
• To turn on / off the interior light, press the light pad. The unit cannot be in lock
mode to perform this operation.
Note: The light will turn OFF after the touch pad is released.
To Next Page
Loading...
Need help?
General
