Magic Chef® Water Dispenser Product Guide
9
Operation
This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors can
accumulate in the tank and water line. Pour and dispose of at least one quart of water prior to
consumption.
Dispensing Cold Water
After setup, it will take up to one hour for the cold water to reach the lowest temperature. During this
time, the compressor may run continuously. The snowflake icon on the front of the unit will light up
once the cold water has reached the target temperature.
Dispensing Hot Water
After setup, hot water will be available in roughly 15-20 minutes. The heat wave icon on the front of the
unit will light up once the hot water has reached the target temperature. In order to dispense hot water,
you have to press and hold down the red button on the front of the hot water dispenser, then press the
lever in.
Changing Bottles
A flashing red LED indicator on the front of the unit (the far right icon of the two bottles) will alert you
when the bottle is empty. Replace the bottle as soon as possible once this indicator lights up. Failure to
replace the bottle may cause the unit to overheat.
To replace the bottle:
1. Open the front panel door.
2. Slide the empty bottle out of the cabinet.
3. Remove the hose assembly from the empty bottle and place it on the hose assembly hanger, or
directly into the new water bottle.
4. Set the empty bottle aside.
5. Place a new bottle in the cabinet. Remove the plastic cap from the top of the bottle and clean
the outside with a cloth.
6. Place the bottle hose into the bottle and slide the collar down until it clicks into place. Push the
head down until the hose hits the bottom of the bottle.
7. Slide the bottle into the cabinet and shut the door.
To Next Page
Loading...
Need help?
General