Why is my product sticking to the Magikitch'n MKG36 Griddle?
Product sticking to the Magikitch'n Griddle can occur if the griddle surface is dirty or un-seasoned, so you should clean and season the griddle surface. It can also happen if the cooking times are too short, in which case you should increase cooking times.
What to do if my Magikitch'n Griddle pilot(s) will not light?
If the pilot(s) on your Magikitch'n Griddle will not light, there are several potential causes: 1. The manual gas valve or gas supply may be turned off or disconnected, so check the gas valve and supply. 2. The unit might not be plugged in, so ensure it is. 3. There could be a faulty ignition module or flame sense circuit, requiring replacement. 4. The power switch(s) may be off, or there could be a faulty control transformer, so check these components. 5. The thermostats may be turned to 'Off'; ensure they are turned on.
Why is my Magikitch'n MKG36 staying hot or overheating?
If your Magikitch'n Griddle stays hot or overheats, check for a thermostat or gas valve failure.
Why does my Magikitch'n MKG36 Griddle have inconsistent surface temperatures?
Inconsistent surface temperatures on your Magikitch'n Griddle can be caused by thermostats that are not calibrated; in this case, calibrate the thermostats. Another possible cause is a thermostat or gas valve failure, which would require replacing the faulty component.
What to do if the pilot ready light will not illuminate on my Magikitch'n MKG36 Griddle?
If the pilot ready light on your Magikitch'n Griddle does not illuminate, it could be due to several reasons: 1. The manual gas valve or gas supply may be turned off or disconnected, so check the gas valve and supply. 2. The unit might not be plugged in, so ensure it is. 3. There could be a faulty ignition module or flame sense circuit, requiring replacement. 4. The power switch(s) may be off, or there could be a faulty control transformer, so check these components.
Why are the edges of my product burning on the Magikitch'n MKG36 Griddle?
Burning edges on your product when using the Magikitch'n Griddle can occur if the heat is set too high, so lower the heat setting. It can also happen if cooking times are too short, so increase them.
Why does my food have a greasy or undesirable flavor when cooked on the Magikitch'n MKG36?
A greasy or undesirable flavor in food cooked on the Magikitch'n Griddle can result from excessive oil or grease on the griddle surface, so reduce the amount used. It can also occur if the heat setting is too low; in that case, increase the heat setting.
Inspect appliance for damage upon delivery and ensure proper electrical connections are made.
Follow clearance guidelines and ensure correct gas supply, pressure, and fuel type.
Proper ventilation and fire safety systems are crucial for safe operation.
Procedures for installing the appliance on a counter or equipment stand and leveling.
Details regulator assembly, gas settings, and gas table for proper fuel supply.
Step-by-step guide for lighting pilots on Snap-Action and Solid State models.
Instructions for initial setup, including surface seasoning and temperature checks.
Step-by-step guide for safely shutting down the appliance.
Procedure for calibrating snap action and electric thermostats for accuracy.
Procedure for calibrating solid state thermostats for accuracy.
Tips for efficient griddle use, thermostat control, and product placement.
Chart of recommended cooking times and temperatures for various foods.
Procedures for cleaning griddle surfaces during operation and at the end of the shift.
Recommended monthly checks for proper operation, safety, and preventative care.
Annual inspection by a qualified technician covering safety, mechanical, and system operations.
Chart to diagnose poor cooking performance issues like sticking, burning, or inconsistent temperatures.
Chart to diagnose operational issues like pilot not lighting or unit not heating.
Details standard accessories included with the griddle, such as legs and gas regulator.
Overview of optional accessories available to customize the griddle's functionality.
Lists available front service shelves with various dimensions and towel bar options.
Details available cutting board sizes and their corresponding part numbers.
Lists available rear warming shelves for different griddle models.
Details available equipment stands with options for legs or casters.
Lists miscellaneous accessories like wall spacers and utensil boxes for added convenience.
General| Model | MKG36 |
|---|---|
| Category | Griddle |
| Cooking Surface | 36 inches |
| Power Source | Gas |
| BTU Output | 90, 000 BTU |
| Burners | 3 |
| Burner Type | U-shaped |
| Temperature Control | Manual |
| Material | Stainless Steel |
| Cooking Surface Material | Steel |
| Temperature Range | 200°F to 550°F |
| Dimensions | 36" W |
To Next Page
