26
MAGNAMED Ventilator Analyzer - VentMeter P/N: 1901509 – Rev 05
Caution
• Follow the central command instructions to calibrate the oxygen concentration
measurement.
• Replacements should be done with the recommended oxygen sensor.
• OXYGEN SENSOR REPLACEMENT:
o MAXTEC – MAX-13 – O2 SENSOR
o MAXTEC - RP16P02 – Tee Adaptor
o MAXTEC - R110P10 – Flow Diverting
7.4 Before Use
This inspection routine is intended to orient the user to carry out a simple procedure and quick equipment test
before each use or at least at the beginning of each working period, assuring high reliability to the
measurements.
7.4.1 Initial Procedures
• The equipment should be turned off.
• Integrity of all accessories and the equipment – visual inspection.
• Check if all the accessories are correctly and firmly connected.
To Next Page
