4 i_i;ii!_i
Use _1/1_ to select the desired location setting,then press
OK,
Initial Setup
7his section wili guide you through the unit's nital setting
which ndudes selecting a language for your on screen menu
and autoprogram, which automat tally scans and memorizes
v ewabie channels.
Before you begin:
Hake sure the unt is connected to antenna or cable.
1 After making all the necessary connections,
press _ to turn on the unit,
• It may take a few moments to turn on the unt for the
first time.
• [Initial Setup] menu appears automatcall7 after the
unt is turned on.
2 Use A/V to select the on screen language from the
choices (Engl sh / Espa_ol/Franca s) on the rght sde of the
]V screen, then press OK.
3 Use A/V to select [Antenna] forIV channels or [Cable]
for C,_[V channels, then press OK.
Select [Retail] store, the unit will be set up with
predefined setting for retail d splays.
Select [Home], the unit s set to maxmze the energy
efl]c ency for home setting and t can be adjusted
through a choice of picture and sound quality accord ng
to your preference. Use this setting to remove the
E St cker fvis ble from the displa}4 ,,_ p.23
When the nitial setup is completed, the lowest
memorized channel with the confirmation message of
the Iocat on sett ng will be d splayed on the IV screen.
You must set [Home] in step 4. Otherwise, [Picture]
and [Sound] settings you adjusted will not be
memorized after the unt goes into standby mode.
If you are, not receiv ng a sgnal fl_m your cable serv ce, contact
the Cabe prov de_:
If you Dess _ or MENU durng autoplsgram, ths setup of TV
channels w be canceed.
The init al autoprogram function can be exr,cuted for ether
[Antenna] or [Cable] ony once.When you change the
connect on (Antenn / Cabe), set [Autoprogram] gan. ,,_ p.17
If them is no signa input fi-om the antenn terminal and no
operat on for several seconds after you turn or, the unit, he pful
hints appears. Follow the instruct ons isted on theTV screen.
• [Autoprogram] wii] begin.
After an initial setup is completed...
• If/ou want to scan the channels automatically again.
[Autoprogram] nlmi,p.17
• You can add the desired cable and analog channels
unmemorized by autoprogram.
[Add Channels] n,_ p.18
• If you want to change to another language.
[Language] n,_ p.23
• If you want to change the location setting.
[Location] n,_ p.23
To Next Page
Loading...
Need help?
General