Magnum Energy ME-MR Series User Manual (English)

Questions and Answers:

S
Sydney OlsonAug 3, 2025
What to do if Magnum Energy Remote Control is non-functional?
- C
  Cheryl GreenAug 3, 2025
  If your Magnum Energy Remote Control is non-functional (no lights, no text on LCD display, and no response when pressing any button), check the communication cable from the inverter to the remote. Ensure it is connected to the REMOTE port and that the correct communications cable is used. A 4-conductor telephone cable may be substituted to determine if the cable is faulty. Also, ensure the inverter batteries are connected and the inverter is operating correctly without any AC power connected, meaning it can invert and power AC loads from batteries.
C
clarkfranciscoAug 12, 2025
How to fix Magnum Energy Remote Control when LCD is locked up?
- A
  anthony10Aug 12, 2025
  If the LCD text display on your Magnum Energy Remote Control is locked up and pushing any button has no response, showing “revision” or “connecting”, try the following: Reset the remote by disconnecting the remote cable from the inverter for 5 seconds and then reconnecting it. Also, check the RJ11 cable connection on the back of the remote, ensuring the RJ11 connector is pushed into the correct port until you feel or hear a “click”. Another possible cause is that the remote is not getting sufficient power from the inverter. Make sure the inverter batteries are connected and the inverter is operating correctly, meaning it should be able to invert and power AC loads from batteries without any AC power connected to the inverter AC inputs.
S
Scott FosterAug 25, 2025
Why are the LEDs and backlight off on my Magnum Energy Remote Control?
- T
  Taylor HumphreyAug 25, 2025
  If the LEDs and backlight are off on your Magnum Energy Remote Control, it might be in Power Saver mode. To reactivate the remote, press any button or turn Power Saver mode off.