Magnum Energy ME-ARC User Manual (English)

Questions and Answers:

M
Matthew SimmonsAug 6, 2025
What to do if Magnum Energy ME-ARC Remote Control is non-functional?
- V
  vjenkinsAug 6, 2025
  If your Magnum Energy Remote Control shows no lights, no text on the LCD display, and doesn't respond to button presses, check the communication cable from the inverter to the remote. Ensure it is connected to the REMOTE port and that you're using the correct cable. A 4-conductor telephone cable can be substituted to test the cable. Also, make sure the inverter is connected to the batteries and operating correctly without AC power connected; it should be able to invert and power AC loads from batteries.
S
Shane JeffersonAug 13, 2025
What to do if Magnum Energy ME-ARC LCD display is locked-up?
- D
  danabakerAug 14, 2025
  If the LCD text display of your Magnum Energy Remote Control is locked up and unresponsive, showing 'revision' or 'connecting', it could be due to a poor connection with the RJ11 cable or insufficient power from the inverter. To resolve this: * Reset the remote by disconnecting the remote cable from the inverter for 5 seconds, then reconnect it. * Check the RJ11 cable connection on the back of the remote, ensuring it's pushed into the correct port until you hear a 'click'. Also, ensure the inverter batteries are connected and the inverter is operating correctly, capable of inverting and powering AC loads from the batteries without AC power connected to the inverter AC inputs.
S
Steven TorresAug 20, 2025
Why are the LEDs and backlight off on my Magnum Energy Remote Control?
- C
  Cassandra RossAug 20, 2025
  If the LEDs and backlight are off on your Magnum Energy Remote Control, it's likely in Power Save mode. To reactivate the remote, press any button or turn off Power Save mode.
C
Christina PerezAug 28, 2025
How to fix unrecognizable letters or symbols on Magnum Energy ME-ARC display?
- N
  Nicole RuizAug 28, 2025
  If your Magnum Energy Remote Control display shows unrecognizable letters or symbols, static electricity may have been discharged into the LCD display. To refresh the display, press and hold the SELECT button for 10 seconds.