Magura MT Series - User Manual

Welcome to the passion people techtip 1, May 2012
How to reroute and shorten the hose without bleeding the brake
Before you start turn the master vertically upwards
Attention: If possible, FIRST cut the hose about 150mm from the master.
Then use an 8mm open spanner and remove first the sleeve nut and then the hose.
To avoid spillage hold the hose!
Attention: if the hose is routed through the frame, take care to shorten it AFTER routing through the frame.
In case of routing the hose through the frame, please order the hose with an additional length of 300mm.
If possible use a plug to close the hose during the routing process.
Take the hose after routing through the frame and check for correct length before shortening it.
Tighten the sleeve nut with the correct torque of 4Nm while HOLDING the hose.

Summary

Rerouting and Shortening Brake Hose

Initial Hose Preparation and Cutting

Cut hose, remove sleeve nut, and hold hose to prevent spillage.

Frame Routing and Hose Length

Shorten hose after frame routing; use extra length or plug if needed.

Securing the Hose Connection

Tighten sleeve nut to 4Nm while holding the hose.

Hose Routing and Adjustment

Adjusting Banjo Bolt Angle

Loosen banjo bolt max 30° counter clockwise and adjust hose angle.

Brake Check After Hose Work

Leak and Function Verification

Check for leaks and control brake function by pulling the lever blade.

Magura MT Series Specifications

General

Brand	Magura
Model	MT Series
Category	Bicycle Accessories
Language	English