To Next PageTo Next PageWhat to do if MAHA TWIN F III 4.0 does not run?
If your MAHA Scissor Lift isn't running, there are several potential causes: * The main switch might be turned off. If so, turn it on. * There could be a power failure. Check for the cause of the power failure. * The power cord might be interrupted. Replace the defective cord. * The fuses might be defective. Replace the fuses.
Why MAHA TWIN F III 4.0 Scissor Lifts does not raise?
If your MAHA Scissor Lift isn't raising, here are a few things to check: 1. The motor rotation might be reversed. Interchange two phases at the main switch. 2. The fluid level could be low. Refill the fluid reservoir. 3. The RAISE button might be defective. Check the button and line, and replace if necessary. 4. The pump intake filter might be dirty. Check and clean the filter.
What to do if support plates lower without control button being pressed on MAHA TWIN F III 4.0 Scissor Lifts?
If the support plates on your MAHA Scissor Lift are lowering without the control button being pressed, it could be due to: * The LOWER solenoid valve not closing completely. Contact service for assistance. * Leakage in at least two hydraulic lines. Check connections for a tight fit and hoses for damage, replace if necessary.
Why MAHA TWIN F III 4.0 Scissor Lifts lift capacity insufficient?
If your MAHA Scissor Lift has insufficient lift capacity, it may be due to a maladjusted pressure valve. In this case, you should contact service.
What to do if MAHA TWIN F III 4.0 Scissor Lifts shows jerky movements?
If your MAHA Scissor Lift is exhibiting jerky movements, it could be due to maladjusted pressure valves. Contact service for assistance.
Why MAHA TWIN F III 4.0 Scissor Lifts does not lower?
If your MAHA Scissor Lift isn't lowering, it could be due to a defective LOWER solenoid valve. Contact service for assistance.
Why MAHA Scissor Lifts raises and lowers considerably faster than usually?
If your MAHA Scissor Lift raises and lowers considerably faster than usual, it may be because the RAISE and/or LOWER solenoid valve is defective. Contact service for assistance.
General| Brand | MAHA |
|---|---|
| Model | TWIN F III 4.0 |
| Category | Scissor Lifts |
| Language | English |
