To Next Page

To Previous Page

2-15

Make sure to set the jack properly in the jacking point. Raising the vehicle with

an improperly positioned jack will damage the underbody of the vehicle or may

allow the vehicle to fall off the jack and cause personal injury.

• Use the jack only for lifting your vehicle during wheel changing

• Do not raise the jack with someone in the vehicle

• When raising the vehicle, do not place any objects on top of or underneath

the jack

• Raise the vehicle only high enough to remove and change the wheel

• Usable extended height of jack is up to the yellow line/mark. Do not raise the

jack above the yellow line.

• Follow jacking instructions

• Do not start or run the engine while your vehicle is supported by the jack

Never get under the vehicle when the vehicle is supported by the jack alone.

Remove the wheel nuts. Lift the flat tyre straight off and place it aside. Roll the spare

wheel into position and align the holes in the wheel with the bolts. Lift up the wheel

and get at least the top bolt started through its hole. Wiggle the wheel and press it

back over the other bolts.

Re-install the wheel nuts with the tapered end inward and tighten by hand. Press the

wheel inward and tighten the wheel nuts further.

W12B24

Never use oil or grease on the bolts or nuts. Doing so may lead to over

tightening of the nuts, wheel nut spanner slip, damage the bolts and also may

cause personal injuries. Also, nuts may loosen and the wheels may fall off, which

could cause a serious accident. If there is oil or grease on any bolt or nut, clean

before installing wheel nuts.

Lower the vehicle completely and tighten the diagonally opposite wheel nuts using

the wheel nut spanner. Turn the jack handle extension counter clockwise using the

jack handle to lower the vehicle, making sure the handle remains firmly fitted onto

the jack handle extension. Make sure the wheel spanner is securely engaged over

the nut. Tighten each nut a little at a time in the diagonally opposite order as shown.

Repeat the process until all the nuts are tight. Do not use other tools or any

additional leverage other than your hands, such as a hammer, pipe or your foot.

GENERAL

Mahindra 2014 Scorpio S10 User Manual

Questions and Answers: