A-8
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
HANDLING PRECAUTIONS FOR ELECTRICAL PARTS
AND WIRING
To ensure safety and prevent damage to the Machine
and surrounding equipment, the following precautions
needs to be taken while handling electrical parts & wiring.
IMPORTANT :
• Check electrical wiring for damage and Loosened
connection every week.
• Do not attempt to modify or remodel any
electrical parts and wiring.
• When removing the battery cable, disconnect the
negative wire first. When Installing the battery
cable, connect the positive first.
• After connecting cables to battery terminals apply
petroleum jelly to them and securely install
terminal covers on them.
• Do not allow dirt and dust to get collected on battery.
• Take care not to let battery liquid spill on your
skin and cloths. If contaminated, wash it in water
immediately.
• Before recharging the battery, remove it from the
machine.
• Before recharging, remove cell caps.
FUSE
• Use fuses with Specified capacity. Never use steel
or copper wire in place of fuse.
CONNECTOR
• For connector with Lock, push lock to separate.
In separating connector do not pull with harness.
• Do not throw or drop electrical parts and wire
harness.
• Do not pour water on electrical parts such as main
switch and alternator.
OIL, DUST AND DIRT
• If flammable material such as fuel, or Lubricant
spills, wipe it off with dry piece of cloth, Do not
approach it with an open flame.
• Replace fuel pipe that is aged.
• Remove dirt and dust accumulated on heated
parts, wiring harness battery etc.
• Use sand paper to remove corrosion, rust from
terminal.
• Repair deformed terminal. Make sure there is no
terminal being exposed or displaced.
• Make sure certain plastic cover is large enough
to cover whole connector.
General
Negative
(–)
Positive
(+)