E-20
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
Transmission
RANGE SECTION
A. Removal
1. Drain oil from Speed and Range section.
2. Split the Tractor between Clutch Housing and
Transmission-case as detailed in splitting of
tractor.
3. Remove the tires.
4. Remove Hydraulic Lift Housing and Range Section
top plate.
NOTE: Place the Transmission-case with axle on
suitable stand and suitable support at front
before starting work on Range Section.
5. Remove the rear PTO cover assembly along with
wet clutch assembly and 540 input shaft and gear
assembly.
6. Remove external circlip inside hub and remove
hub.
7. Remove PTO middle support bearing rear circlip.
8. Remove PTO intermediate shaft with ball bearing
from rear side.
To Next Page
Loading...
