E-65
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
Brakes
3. Cleaning & Inspection
a. Clean all parts with suitable solvent.
b. Check friction plate for wear, crack and splines
of plate with bull shaft. If excessive play or
damaged, dents found replace the friction plate.
c. Inspect the linkage for wear.
NOTE: Discard the actuating disc spring if found weak
or end are deformed.
d. Replace the worn or faulty parts.
NOTE: Removal, dismantling and installation
procedure are same with other side brakes.
5. Installation
a. Reverse procedure of removal and dismantling.
b. Tighten the bolts at specified torque and check
all friction plates and disc intermediates are free.
To Next Page
Loading...
