P12
Touch the 'M' key: the display shows 'S-'.
Touch the 'DOWN' key: the display flashes.
Touch and hold the 'M' key for 2s until the display shows '000'.
The lower limit is now stored.
Change the RESET height:
Delete height limits:
Touch the 'M' key: the display shows 'S-'.
Touch and hold the 'M' key for 2s until the display shows '555'.
Both upper and lower limits are deleted.
Memory Height Setting:
Touch the ‘M’ key, the display shows ‘S-’, Touch one number key
from 1-4, the current height will be stored to that key. Press that key,
your desk will move to the height automatically.
Reset Exception Protection:
Condition
The digital display shows error E07/E08/E09
Disconnecting/Reconnect power, the error still remains.
Pressing any key has no effect.
Operation
Hold the 'DOWN' key for 5s, the digital display shows RST.
Release and hold the 'Down' key again to reset the desk.
(Note: This operation is also applicable to forced reset.
Please lower the desk to the lowest position first when forced reset.)
'E07'
'E08'
'E09'
'S-'
'RST'
Height Setting
The next parts can be set according to your preference.
Set the upper limit:
Set the lower limit:
Enter the RST mode (see instructions above).
Touch and hold the 'M' key for 5s: the display shows the reset height,
and the screen flashes.
Touch and hold the 'UP' key or 'DOWN' key to change the value.
The display switches back to 'RST' if no operation is detected for 5s,
indicating the change is successful.
Quit the RST mode (see instructions above).
'S-' '999'
'S-' '000'
'S-' '555'
'RST' 'RST'
Height setting
Hold for 2s
Hold for 2s
Hold for 2s
Hold for 5s
Hold for 5s
Touch the 'M' key: the display shows'S-' .
Touch the 'UP' key: the display flashes.
Touch and hold the 'M' key for 2s until the display
shows '999'. The upper limit is now stored.
To Next Page
Loading...
