Major 2600 LGP User Manual (English)

Questions and Answers:

C
crystal36Jul 25, 2025
What to do if the delivery pressure of my Major Farm Equipment centrifugal pump is too low?
- A
  Adam BarreraJul 25, 2025
  If the delivery pressure isn't reaching working values, there are several potential causes. The impeller lugs might be worn or broken, requiring impeller replacement. The RPM could be too low; try increasing it to a maximum of 600 RPM. The tractor PTO may lack sufficient power, so increase the power. Also, the diameter of the outlet hole of the nozzle of the rotating jet may be too wide; in that case, decrease the diameter of the outlet hole.
C
Carla RamirezJul 31, 2025
What to do if sewage does not exit from the delivery tube of my Major 2600 LGP centrifugal pump?
- E
  Erica RandolphAug 1, 2025
  If sewage isn't exiting the delivery tube, first check for obstructions in the delivery tube and eliminate them. Next, ensure that the lever gate valve above the centrifugal pump is open. Finally, verify that the handle of the exhauster/compressor is positioned towards the left; if not, position the handle accordingly.
E
elittleAug 7, 2025
Why is excessive sewage exiting from the packing seal of my Major 2600 LGP Farm Equipment centrifugal pump?
- T
  Tricia GilmoreAug 7, 2025
  Excessive sewage exiting from the packing seal is likely due to a worn or burnt graphitized cord. Replace the graphitized cord, ensuring you don't overtighten it.
D
danielsdeborahAug 12, 2025
How to fix irregular exit of sewage from delivery of centrifugal pump in Major Farm Equipment?
- D
  derrick81Aug 12, 2025
  Irregular sewage exit can be caused by a couple of things. First, the sewage might be too dense; if so, dilute it. Second, there might be air infiltration; in that case, eliminate the infiltration.
J
Jenna RobertsAug 18, 2025
What to do if the mechanical seal of my Major 2600 LGP centrifugal pump whistles?
- R
  Robert HesterAug 18, 2025
  A whistling mechanical seal, present in certain versions, indicates it's likely burnt due to a lack of sewage. The suggested solution is to replace the mechanical seal.