6
Press and hold to BT
discoverable
Operating your remote control
Press and slide the back cover to open the battery compartment of the remote
control.
Insert two AAA size batteries. Make sure the (+) and (-) ends of the batteries
match the (+) and (-) ends indicated in the battery compartment.
Close the battery compartment cover.
Connection and Preparation
Connect the power adaptor to the back of device and plug it into power socket. It
starts up after switching on the device.
Connecting the network
• A broadband connection in combination with a wireless access point, router
or similar network device.
• The network device needs to support WiFi (802.11 a/b/g/n) wireless
connection.
Make sure you have setup the wireless network and you have the WEP, WPA or
WPA2 security password to activate the connection. You may also use the WPS
(WiFi Protected Setup) function for easy pairing between the network device and
the radio. Check if the light indicators on the network device are in appropriate
status.
To Next Page
Loading...
Need help?
General
