Make Noise 0-Coast - Arpeggiator Settings

Here are the seven pages. Each page is indicated by number of presses it took to navigate to it, as well as behavior of Activity
Windows while on the Page. For example, the second page is {Legato}, which takes [TWO PRESSES] to reach, and is indicated
by PGM_A = <Pulsing>.
1. {Arpeggiator}: PGM_A = <ON>
This selects one of two arpeggiator types. (Arpeggiator is activated from the performance page by [PRESSING]
PGM_A and PGM_B, with PGM_B <lighting> to indicate Arpeggiator = ON.
• PGM_B = <OFF> – Latch & Shift = OFF (default).
This is a traditional arpeggiator, which plays any held notes in the order they are played, at the 0-Coast's
current Clock Rate.
• PGM_B = <ON > – Latch & Shift = ON.
This arpeggiator adds notes in the order they are played, and continues playing them in order after they are
released. Playing any note a second time removes it from the arpeggio. Up to twenty notes can be added. If
more than twenty notes are played, each new note causes the rst note to be removed from the arpeggio.
2. {Legato}: PGM_A = <PULSES>
• PGM_B =<ON> – Legato = ON (default). MIDI A Gate goes high when the rst note-on is received, and does not go
low until all note-os have been received. In other words there is a single Contour until all notes are
released.
• PGM_B = <OFF> – Legato = OFF. MIDI A Gate goes high with each new note-on, even if the previous notes are still
being held. With short Onset times, this can result in a new Contour for every note played even if keys are
not released between notes.
3. {MIDI Learn}: MIDI_A = <ON>
This allows the possibility of MIDI A and MIDI B to receive data on dierent MIDI channels. Select which
channel(s) are to be programmed, then send MIDI data to allow it to learn, then [HOLD] PGM_B to nish
learning.
• [PRESS] PGM_B to select MIDI CV channel
• MIDI_A = <ON > – Ready to Learn MIDI A
• MIDI_B = <ON>– Ready to Learn MIDI B
• MIDI A & MIDI B =<ON> – Ready to Learn Both
• [Play] MIDI data on Channel to be Learned
• [HOLD] PGM_B – Learn = <ALL LEDs FLASH 2X> to indicate Learned & Exit
• [HOLD] PGM_A – set to MIDI CH . ALL (default)
4. {MIDI B CV source}: PGM_A = <ON>, MIDI_B = <PULSES>
• PGM_B = <OFF> – Note number.
• PGM_B = <ON> – Velocity (default).
• PGM_B = <PULSE> – Mod Wheel.
• PGM_B = <FLASH> – LFO ([TAP] PGM_A twice or more to set frequency). This is a Triangle wave LFO with
user-dened frequency.
12