9
Patch Ideas:
The New Bongo:
Set up a VCO for Two-Operator FM by applying a SINE wave to its Linear FM input and patching the resulting
waveform to OPTOMIX’s CHannel 1 Signal INput. Patch PRESSURE POINTS Common Gate OUTput to the
OPTOMIX’s CHannel1 STRIKE INput and PRESSURE POINTS CHannel 3 GATE OUTput to the OPTOMIX’s
CHannel 1 DAMP INput. Strike the “Bongo” by <TAPPING> PP Touchplate 4 and “dampen” the bongo
during or after striking it by <TAPPING> PP Touchplate 3. Use the DAMP Combo Pot to set the amount of
DAMPening.
FM Pings:
Patch an FM source such as an audio-rate SINE wave to OPTOMIX CHannel1 Signal INput. Patch the
CHannel1 OUTput to the Linear FM INput on STO or another VCO of your choice. Adjust OPTOMIX
CONTROL Combo Pot full CCW (0%). Patch a Trigger or Gate source to OPTOMIX CHannel1 STRIKE INput
to “ping” the destination VCO with a short burst of FM. Adjust the DAMP Combo Pot to taste.
To Previous Page
Loading...