MAKER MADE M2 - What’s in the Box?

5
M2 ASSEMBLY GUIDE
DUE v1.2 Control Board, Shield,
and case
10’ MicroUSB to USB cord AC/DC Power Adapter and cord X, Y, and Z Axis Motors
(ETONM) (3)
X, Y, and Z Motor Power Cables
(JST XH 6 pin x2, (JST XH 6 pin
to PH 6 pin x1)
Motor Mounting Brackets (2) Stud Mounts (4) with shock
absorption strip
M Ring Carriage
Roller Bearing Carriges (2) Z-Axis Mount L-Brackets (3) Z-Axis Assembly Sled
Router Clamp Roller Bearings (4) Chains 335cm/11’ (2) Dust Collection Elbow
Spring Maker Made Router Bit Starter
Set
Maker Made Sticker, marker,
welcome note, and USB Drive
Bag A
WHAT’S IN THE BOX?
This work is licensed under the creative commons Attribution
NonCommercial-NoDerivatives 4.0 International license. Last Updated 11.09.2020
Version 1.14