Need help?Do you have a question about the MAKER MADE M2 and is the answer not in the manual?
Complete the Z-axis assembly with motor bracket, motor, gear, and belt.
Assemble roller bearing carriages and mount L-brackets to the ring.
Attach chains to the top beam and connect them to the motors.
Verify connection, set Z-steps, unlock, measure motor distance and workspace.
Establish the M2's origin (0,0) and set the Z-axis bit height on the material.
Load Gcode into the controller and begin the cutting process.
General| Weight | Unknown |
|---|---|
| Cutting Area | 4 feet x 8 feet |
| Compatible Software | Fusion 360, Easel |
| Type | CNC Router |
| Blade Material | Not applicable |
| Blade Length | Not applicable |
| Handle Material | Not applicable |
| Overall Length | Not applicable |
To Next Page
