45
M2 ASSEMBLY GUIDE
10. HOME TO (0,0):
The home position must be set on your M2 before you can CNC or jog your motors. If your
sled is not already in the center of your wasteboard, click the Set Home command and move
the M2 sled and chains to the center of your wasteboard using the X-, X+, Y-, and Y+ jog
commands on the right.
NOTE: Home must be set before you attempt to jog. If you try to jog before setting home,
the sled will continuiously move in the direction you clicked until you unplug the DUE Board
from power.
This work is licensed under the creative commons Attribution
NonCommercial-NoDerivatives 4.0 International license. Last Updated 8.12.2020
Version 1.8
To Next Page
Loading...
