44
M2 ASSEMBLY GUIDE
To measure the motor offset, measure from where the chain would be taught across the top
to the top of your wasteboard. Input values and press save. These values will now be saved
directly on your M2 for future use.
9. MACHINE SETTINGS - MEASURE WORKSPACE
Before the M2 will work properly, the workspace dimensions must be entered. Measure
the size of your workspace and press enter. The standard 4x8’ values are default.
Configuratin will be set after your first cut.
This work is licensed under the creative commons Attribution
NonCommercial-NoDerivatives 4.0 International license. Last Updated 8.12.2020
Version 1.8
To Next Page
Loading...
