47
M2 ASSEMBLY GUIDE
12. UPLOAD GCODE:
Click “upload Gcode” and select the Gcode file you created in Easel.
You’ll know your Gcode loaded correctly when CNCjs displays the paths of the Gcode you
loaded! You already set the dimensions and depths in Easel for the M2, so it’s ready to start!
We recommend a one foot or one meter square as your first test cut for calibration.
This work is licensed under the creative commons Attribution
NonCommercial-NoDerivatives 4.0 International license. Last Updated 8.12.2020
Version 1.8
To Next Page
Loading...
