2
ENGLISH (Original instructions)
SPECIFICATIONS
Model DBN500
Brad nail size 18 Ga x 15, 20, 25, 30, 32, 35, 38, 40, 45, 50 mm
Brad nail magazine capacity 100 pcs
Dimensions (L x W x H) 294 mm x 97 mm x 318 mm
Rated voltage D.C. 18 V
Net weight 3.3 kg 3.5 kg
Standard battery cartridges
BL1815 / BL1815N /
BL1820 / BL1820B
BL1830 / BL1840 / BL1840B /
BL1850 / BL1850B
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
END311-1
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ Wear safety glasses.
･ Do not use on scaffoldings, ladders.
･ Keep fingers away from trigger when
not driving fasteners to avoid accidental
firing.
･ Only for EU countries
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of the European
Directives, on Waste Electric and
Electronic Equipment and Batteries and
Accumulators and Waste Batteries and
Accumulators and their implementation
in accordance with national laws,
electric equipment and batteries and
battery pack(s) that have reached the
end of their life must be collected
separately and returned to an
environmentally compatible recycling
facility.
ENE073-1
Intended use
The tool is intended for fastening on interior work and
furniture work.
ENG905-1
Noise
The typical A-weighted noise level determined
according to EN60745:
Sound pressure level (L
pA
) : 79 dB (A)
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
ENG904-2
Vibration
The vibration total value determined according to
EN60745:
Vibration emission (a
h
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
Cd
Ni-MH
Li-ion
To Next Page
Loading...
Need help?
General
