To Next PageTo Next PageWhy won't my Makita Chainsaw start?
Your Makita Chainsaw might not start due to several reasons: First, ensure that two charged battery cartridges are properly installed. Second, the battery voltage may be low, requiring you to recharge or replace the battery cartridges. Finally, check if the main power switch is turned off, as the chainsaw automatically turns off after a period of inactivity. Turn the main power switch on again.
How to fix no oil on chain of Makita Chainsaw?
If there's no oil on the chain of your Makita Chainsaw, the oil tank might be empty, so you should fill it. Another possible cause is a dirty oil guide groove, which requires cleaning. Also, check the oil delivery and adjust the amount of oil delivered with the adjusting screw.
What to do if Makita Chainsaw motor stops after short use?
If the motor of your Makita Chainsaw stops running after a short period, it's likely due to a low battery charge level. Try recharging the battery cartridges. If recharging doesn't solve the problem, consider replacing the battery cartridge.
Why my Makita Chainsaw does not reach maximum RPM?
If your Makita Chainsaw isn't reaching maximum RPM, it could be due to a few reasons. First, make sure the battery cartridge is correctly installed as described in this manual. Another reason may be that the battery power is dropping, so try recharging the battery cartridges, and if that doesn't work, replace them. If these steps don't resolve the issue, it may be a problem with the drive system.
What causes abnormal vibration in Makita Chainsaw?
Abnormal vibration in your Makita Chainsaw can be caused by a loose guide bar or saw chain. In this case, you should adjust the guide bar and saw chain tension.
What to do if Makita Chainsaw saw chain does not run?
If the saw chain on your Makita Chainsaw isn't running, it's possible that the chain brake is activated. Try releasing the chain brake.
Why is the main power lamp blinking on my Makita Chainsaw?
The main power lamp on your Makita Chainsaw may be blinking because the switch trigger is pulled under an unoperable condition. Ensure the main power switch is on and the chain brake is released before pulling the switch trigger.
General| Type | Indoor battery charger |
|---|---|
| Product type | Battery charger |
| Product color | Black, Blue |
| Battery voltage | 18 V |
| Battery capacity | - Ah |
| Charging voltage | 14.4 - 18 V |
| USB port current | 1.5 A |
| Battery technology | - |
| Recharge indicator | Yes |
| Brand compatibility | Makita |
| Battery recharge time | 0.37 h |
| Maximum charging time | 0.75 h |
| Battery capacity (max) | 5 Ah |
| Battery capacity (min) | 3 Ah |
| Power protection features | Over current, Over voltage, Overheating |
| Number of batteries supported | 2 |
| Compatible battery technologies | Lithium-Ion (Li-Ion) |
| Quantity per pack | 1 pc(s) |
Weight and Dimensions| Weight | 2245 g |
|---|
