Makita DFT024F User Manual

8 ENGLISH
LED indicator / Beeper
1
► 1. LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function Status of the tool Status of the LED indicator/beeper Action to be taken
LED indicator Beeper
Check of the LED indi-
cator, light and beeper
operation
When the battery car-
tridge is installed, the tool
checks for its LED indica-
tor, light and beeper.
Lights up rst in green,
next red.
(And then the light
comes on.)
A series of very short
beeps
–
Detection of switch
trigger operation when
installing battery
When the battery car-
tridge is installed with
the switch trigger pulled,
the tool stops to avoid
unintentional start.
Blinks in red and green
alternatively.
A series of short beeps Release the switch
trigger.
Auto-stop with fastening
completion
The tool setting has
been achieved and the
tool has stopped.
Lights up in green for
approximately one
second.
– –
Alarm against insu󰀩-
cient fastening
The tool has not com-
pleted the tool setting
because the switch trigger
has released before
reaching the set values.
Otherwise, the settings of
"Failure Criteria for Phase"
has been achieved.
Lights up in red. A long beep Retighten the screw.
Intermission between
the phases
The tool is in the inter-
mitting period congured
by the setting of "Shift to
the next Phase".
Lights up or blinks in
green (depending on
settings)
– –
Double-hitting detection
When the operator
starts to re-fasten an
already-fastened screw,
the tool detect it and stops.
Lights up in red. A long beep –
Alarm for low battery
capacity
The battery power
became low and it is
time to replace the
battery cartridge.
Blinks in red slowly. A series of long beeps Replace the battery with
fully charged one.
Auto-stop with low
remaining battery
capacity
The battery power is
almost used up and the
tool stopped.
Lights up in red. A long beep Replace the battery with
fully charged one.
Anti-reset of controller
The battery voltage dropped
abnormally for some rea-
son, and the tool stopped.
Blinks in red and green
alternatively.
A series of short beeps Replace the battery with
fully charged one.
Overheat protection The motor or the control-
ler heated up abnormally
and the tool stopped.
Blinks in red quickly. A series of short beeps Remove the battery car-
tridge immediately and
cool the tool down.
Failure to detect heat
of motor
The detection unit of
the motor fails to detect
the heat because the
cord has broken or other
reasons.
Blinks in red quickly. A series of short beeps
Remove the battery cartridge
and cool the tool down. If the
indicator does not stop, ask
your local Makita Service
Center for repair.

Makita DFT024F Specifications

General

Brand	Makita
Model	DFT024F
Category	Power Screwdriver
Language	English