4
ENGLISH (Original instructions)
Explanation of general view
SPECIFICATIONS
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
ENE033-1
The tool is intended for screw driving in wood, metal and
plastic.
General power tool safety
warnings
GEA010-2
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
CORDLESS SCREWDRIVER
SAFETY WARNINGS
GEB139-1
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a “live” wire may make exposed metal parts
of the power tool “live” and could give the operator an
electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
6. Always secure workpiece in a vise or similar hold-
down device.
1. Red part
2. Button
3. Battery cartridge
4. Indicator lamps
5. Check button
6. Switch trigger
7. Reversing switch lever
8. Front lamp
9. LED indicator
10. Adjust grip
11. Ring
12. Adjust ring
13. Scale
14. Hole for adjust grip
15. Yellow line
16. Compression spring
17. Bit
18. Sleeve
19. Bit-piece
20. Limit mark
21. Brush holder cap
22. Screwdriver
Model DFT043F DFT083F DFT125F
Fastening torque
Hard joint 1 - 4 N•m 3 - 8 N•m 5 - 12 N•m
Soft joint 1 - 4 N•m 3 - 8 N•m 5 - 12 N•m
No load speed (min
-1
) 80 80 150
Dimensions (L x W x H) 200 mm x 72 mm x 255 mm
Net weight 1.3 - 1.7 kg
Rated voltage D.C. 14.4 V
Battery cartridge BL1415N/BL1415NA/BL1430/BL1430B/BL1440/BL1450/BL1460A/BL1460B
Charger DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF
To Next Page
Loading...
Need help?
General
