How to fix no oil on the chain of my Makita DUC304 Chainsaw?
If there's no oil on the chain of your Makita Chainsaw, first check if the oil tank is empty and fill it if necessary. Also, inspect the oil guide groove for dirt and clean it. If the oil delivery is poor, adjust the amount of oil using the adjusting screw.
Why does my Makita Chainsaw not start?
Your Makita Chainsaw might not be starting due to several reasons: the battery cartridge may not be installed—install a charged battery cartridge. There could be a battery problem, such as low voltage—recharge the battery cartridges, or replace them if recharging isn't effective. Alternatively, the main power switch might be off—turn the main power switch on.
How to troubleshoot a Makita DUC304 that does not start?
If your Makita Chainsaw does not start, a possible cause is that the battery cartridge is not installed. To fix this, install a charged battery cartridge. Another reason could be a battery problem such as low voltage. In this case, try recharging the battery cartridges; if that doesn't work, replace the battery cartridge. Also, the main power switch might be off. If so, turn the main power switch on again, as the chainsaw automatically turns off if left unused for a while.
What to do if there is no oil on the chain of my Makita DUC304 Chainsaw?
If there is no oil on the chain of your Makita Chainsaw, check the following: First, the oil tank may be empty, so fill it. Second, the oil guide groove may be dirty and needs cleaning. Third, the oil delivery might be poor, so adjust the amount of oil delivery with the adjusting screw.
Why the saw chain cannot be installed on my Makita Chainsaw?
If the saw chain cannot be installed on your Makita Chainsaw, the combination of saw chain and sprocket is not correct. Use the correct combination of saw chain and sprocket by referring to the section for specifications.
What to do if the saw chain does not run on my Makita DUC304 Chainsaw?
If the saw chain of your Makita Chainsaw does not run, it is likely because the chain brake is activated. Release the chain brake to allow the chain to run.
What to do if my Makita Chainsaw motor stops running after a little use?
If your Makita Chainsaw motor stops after a short time, the battery's charge level may be low. Recharge the battery cartridges, and if that doesn't work, replace the battery cartridge.
What to do if my Makita Chainsaw does not reach maximum RPM?
If your Makita Chainsaw isn't reaching maximum RPM, it could be due to a few reasons. First, make sure the battery cartridge is installed properly as described in this manual. Another possibility is that the battery power is dropping; in this case, recharge the battery cartridge, or replace it if recharging isn't effective.
Why is my Makita DUC304 Chainsaw not reaching maximum RPM?
If your Makita Chainsaw is not reaching maximum RPM, the battery cartridge might be installed improperly; make sure to install it correctly as described in the manual. It's also possible that the battery power is dropping, so try recharging or replacing the battery cartridge. If these steps don't resolve the issue, it could be a problem with the drive system, which would require professional repair from an authorized service center.
What to do if my Makita DUC304 Chainsaw motor stops after a little use?
If the motor of your Makita Chainsaw stops running after a short period, it's likely due to a low battery charge. Recharge the battery. If the issue persists after recharging, consider replacing the battery cartridge.
General| Bar Length | 30 cm (12") |
|---|---|
| Voltage | 36 V |
| Battery Type | Lithium-ion |
| Chain Pitch | 3/8" |
| Type | Cordless |
| Chain Gauge | 1.1 mm |
To Next Page
