What to do if my Makita DUC302RF2 motor stops running after a little use?
If your Makita Chainsaw motor stops running soon after you start using it, it is likely that the battery's charge level is low. Try recharging the battery cartridge. If recharging isn't effective, you may need to replace the battery cartridge.
How to fix no oil on the chain of my Makita Chainsaw?
If your Makita Chainsaw isn't oiling the chain, there are a few things to check. First, make sure the oil tank isn't empty; if it is, fill it. Also, the oil guide groove might be dirty, so clean it. Finally, ensure that the oil delivery is adjusted properly.
Why does my Makita Chainsaw not start?
If your Makita Chainsaw does not start, make sure that two charged battery cartridges are installed. If the batteries are installed, the issue might be a battery problem, such as under voltage. Try recharging the battery cartridge. If recharging is not effective, replace the battery cartridge.
Why my Makita Chainsaw does not reach maximum RPM?
If your Makita Chainsaw does not reach maximum RPM, it might be due to a few reasons. First, ensure the battery cartridge is correctly installed as described in the manual. If the battery power is low, recharge it, and if that doesn't work, replace the battery cartridge. If the drive system isn't working correctly, it's best to seek repair from your local authorized service center.
What to do if the chain does not run on my Makita DUC302RF2 Chainsaw?
If the chain on your Makita Chainsaw isn't running, the chain brake might be activated. Try releasing the chain brake.
Why is my Makita DUC302RF2 Chainsaw having abnormal vibration?
If you experience abnormal vibration with your Makita Chainsaw, stop the machine immediately! Check if the guide bar or saw chain is loose and adjust the tension. If the issue persists, it could be a tool malfunction, requiring repair from an authorized service center.
What to do if chain does not stop even the chain brake is activated on my Makita Chainsaw?
If the chain on your Makita Chainsaw doesn't stop even when the chain brake is activated, stop the machine immediately! This could be due to a worn-down brake band, which requires repair from an authorized service center.
General| Bar Length | 30 cm (12") |
|---|---|
| Voltage | 18V |
| Battery Type | Lithium-Ion |
| Battery Capacity | 5.0 Ah |
| Chain Pitch | 3/8" |
| Power Source | Battery |
| Type | Cordless |
| Chain Gauge | .050 inch |
| Oil Tank Capacity | 200 ml |
To Next Page
