What to do if there is no oil on the Makita DUC305 Chainsaw chain?
If there's no oil on the chain of your Makita Chainsaw, it could be due to several reasons. First, check if the oil tank is empty and fill it if needed. Another possibility is that the oil guide groove is dirty, so try cleaning it. Finally, there might be poor oil delivery, in which case you should adjust the amount of oil delivery with the adjusting screw.
What to do if Makita Chainsaw saw chain does not run?
If the saw chain on your Makita Chainsaw isn't running, it's possible that the chain brake is activated. Try releasing the chain brake.
What to do if Makita DUC305 Chainsaw motor stops after short use?
If the motor of your Makita Chainsaw stops running after a short period, it's likely due to a low battery charge level. Try recharging the battery cartridges. If recharging doesn't solve the problem, consider replacing the battery cartridge.
How to fix no oil on chain of Makita DUC305?
If there's no oil on the chain of your Makita Chainsaw, the oil tank might be empty, so you should fill it. Another possible cause is a dirty oil guide groove, which requires cleaning. Also, check the oil delivery and adjust the amount of oil delivered with the adjusting screw.
What to do if my Makita DUC305 Chainsaw motor stops quickly after starting?
If the motor of your Makita Chainsaw stops running soon after you start using it, it could be due to a low battery charge. Try recharging the battery cartridges. If recharging doesn't solve the issue, consider replacing the battery cartridge.
What to do if my Makita Chainsaw chain is not getting oil?
If there is no oil on the chain of your Makita chainsaw: * Check if the oil tank is empty and fill it if needed. * Inspect the oil guide groove for dirt and clean it. * Adjust the amount of oil delivery with the adjusting screw if the oil delivery is poor.
Why my Makita DUC305 does not start?
Your Makita Chainsaw might not start because two battery cartridges are not installed. Make sure to install two charged battery cartridges. Another reason could be a battery problem, such as low voltage. In this case, recharge the battery cartridges, and if that doesn't work, replace them. Also, the main power switch may be off. If the chainsaw is left un-operated for a while, it automatically turns off, so turn the main power switch on again.
General| Type | Cordless Chainsaw |
|---|---|
| Motor Type | Brushless |
| Voltage | 18V |
| Oil Tank Capacity | 0.2 L |
| Chain Pitch | 3/8 inch |
| Automatic Chain Oiler | Yes |
| Tool-less Chain Adjustment | Yes |
| Power Source | Battery |
| Bar Length | 30 cm |
To Next Page
