Why does my Makita Chainsaw motor stop running quickly?
If the motor of your Makita Chainsaw stops running after only a short period of use, the battery's charge level is likely low. Recharge the battery cartridges, and if recharging isn't effective, consider replacing the battery cartridge.
Why my Makita Chainsaw does not start?
Your Makita Chainsaw might not start because two battery cartridges are not installed. Make sure to install two charged battery cartridges. Another reason could be a battery problem, such as low voltage. In this case, recharge the battery cartridges, and if that doesn't work, replace them. Also, the main power switch may be off. If the chainsaw is left un-operated for a while, it automatically turns off, so turn the main power switch on again.
How to fix no oil on chain of Makita Chainsaw?
If there's no oil on the chain of your Makita Chainsaw, the oil tank might be empty, so you should fill it. Another possible cause is a dirty oil guide groove, which requires cleaning. Also, check the oil delivery and adjust the amount of oil delivered with the adjusting screw.
What to do if there is no oil on the Makita DUC400PT2 Chainsaw chain?
If there's no oil on the chain of your Makita Chainsaw, it could be due to several reasons. First, check if the oil tank is empty and fill it if needed. Another possibility is that the oil guide groove is dirty, so try cleaning it. Finally, there might be poor oil delivery, in which case you should adjust the amount of oil delivery with the adjusting screw.
What to do if my Makita Chainsaw motor stops running after a little use?
If the motor of your Makita Chainsaw stops running after a short period, the battery's charge level may be low. Recharge the battery cartridges. If recharging isn't effective, consider replacing the battery cartridge.
What to do if my Makita DUC400PT2 Chainsaw chain does not run?
If the saw chain of your Makita Chainsaw does not run, the chain brake may be activated. Ensure that you release the chain brake.
What causes abnormal vibration in my Makita Chainsaw?
If your Makita Chainsaw experiences abnormal vibration, it could be due to a loose guide bar or saw chain. Adjust the guide bar and saw chain tension to resolve this issue.
How to fix a Makita DUC400PT2 that does not reach maximum RPM?
If your Makita Chainsaw isn't reaching its maximum RPM, it could be due to a few reasons. First, ensure that the battery cartridge is installed correctly. If the battery power is dropping, try recharging the battery cartridges or replacing them if recharging is not effective.
Why is the main power lamp blinking on my Makita DUC400PT2?
The main power lamp on your Makita Chainsaw may be blinking because the switch trigger is pulled under an unoperable condition. Ensure the main power switch is on and the chain brake is released before pulling the switch trigger.
What causes abnormal vibration in Makita Chainsaw?
Abnormal vibration in your Makita Chainsaw can be caused by a loose guide bar or saw chain. In this case, you should adjust the guide bar and saw chain tension.
General| Type | Cordless Chainsaw |
|---|---|
| Battery Type | Lithium-Ion |
| Oil Tank Capacity | 0.2 L |
| Chain Pitch | 3/8" |
| Battery Capacity | 5.0 Ah |
| Voltage | 36V |
| Chain Speed | 20 m/sec |
To Next Page
