Why is the main power lamp blinking green on my Makita Cordless Saw?
The main power lamp blinking green on your Makita Cordless Saw indicates the switch trigger is being pulled under an unoperable condition. Ensure the main power switch is on and the chain brake is released before pulling the switch trigger.
What to do if there is no oil on the chain of my Makita DUC406 Chainsaw?
If you notice no oil on the chain of your Makita Chainsaw, the oil tank might be empty, so refill it. Another possible reason is a dirty oil guide groove, which requires cleaning. You may also need to adjust the amount of oil delivery with the adjusting screw if the oil delivery is poor.
What to do if the saw chain does not run on my Makita DUC406?
If the saw chain of your Makita Chainsaw does not run, it is likely because the chain brake is activated. Release the chain brake to allow the chain to run.
Why the saw chain cannot be installed on my Makita DUC406 Chainsaw?
If the saw chain cannot be installed on your Makita Chainsaw, the combination of saw chain and sprocket is not correct. Use the correct combination of saw chain and sprocket by referring to the section for specifications.
What causes abnormal vibration in my Makita Cordless Saw?
If you experience abnormal vibration with your Makita Cordless Saw, immediately stop the machine. Check for a loose guide bar or saw chain and adjust the tension. If the problem persists, it may indicate a tool malfunction.
Why is Torque Boost mode not available on my Makita Cordless Saw after replacing the battery?
If the Torque Boost mode isn't available after replacing the battery in your Makita Cordless Saw, continue using the tool in normal mode until the installed battery is empty. Then, replace or recharge the battery.
Why is the main power lamp blinking green on my Makita DUC406?
If the main power lamp on your Makita Chainsaw is blinking green, it means that the switch trigger is being pulled under an inoperable condition. Pull the switch trigger after the main power switch is turned on and the chain brake is released.
Why is the Torque Boost mode not available on my Makita DUC406 Chainsaw?
If the Torque Boost mode is not available on your Makita Chainsaw after replacing the battery cartridge, use the tool in the normal mode until the installed battery cartridge becomes empty, and then replace the battery cartridge with a fully charged one, or recharge the battery cartridge.
What does it mean when the main power lamp is blinking green on my Makita Chainsaw?
If your Makita Chainsaw's main power lamp is blinking green, it means the switch trigger is being pulled under an inoperable condition. Ensure the main power switch is turned on and the chain brake is released before pulling the switch trigger.
Why does the motor of my Makita DUC406 Chainsaw stop after a little use?
If your Makita Chainsaw motor stops running after a short period, the battery charge level is likely low. Recharge the battery cartridges, and if recharging doesn't help, consider replacing the battery cartridge.
To Next Page
General
