What to do if the brushroll does not rotate on my Makita DVC560PT2 Vacuum Cleaner?
If the brushroll on your Makita Vacuum Cleaner isn't rotating, ensure the appliance isn't locked in the upright position. Also, if the brushroll error indicator is lit, inspect the brushroll (body, cap, and joint) for any entanglements.
How to fix a hard to move caster wheel on Makita DVC560PT2?
If the caster wheel on your Makita Vacuum Cleaner is hard to move, it's likely due to debris entangled in the caster wheel. Clean the debris from the caster wheel to resolve this issue.
Why does my Makita DVC560PT2 Vacuum Cleaner have weak suction power?
Weak suction power in your Makita Vacuum Cleaner can stem from several causes. The indicator of excess dust might be lit, in which case you should replace the filter bag, or unfold and shake the filter bag to clear any clogs if it's not full. Ensure the HEPA filter is clean, and inspect the hose and pipe for blockages. Check for entanglement around the brushroll, and lower the brushroll height if it's too high. If the brushroll hair is short, consider replacing the brushroll and lowering its height. Also, ensure the appliance isn't in low mode and that the brushroll, pipe, or hose are properly installed.
What to do if my Makita Vacuum Cleaner is making a loud driving noise?
Loud driving noise in your Makita Vacuum Cleaner can be due to several factors. If the appliance is in high mode, switch to a lower mode. Check the brushroll for any entangled debris. If the filter bag is full, replace it. Also, clean or replace the HEPA filter, and inspect the hose and pipe for any clogs.
Why does the indicator of excess level of dust blink after a little use on my Makita Vacuum Cleaner?
If the indicator of excess dust level blinks after only a little use with your Makita Vacuum Cleaner, it could be because the filter bag is folded. Make sure to unfold the entrance of the filter bag before setting it.
Why is the LED lamp not lighting on my Makita DVC560PT2?
If the LED lamp on your Makita Vacuum Cleaner isn't lighting, it might be because the LED lamp setting is off. During operation, press and hold the battery check / LED lamp button to turn on the LED lamp.
General| Brand | Makita |
|---|---|
| Model | DVC560PT2 |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page
